Intense Atomic Inline Co2 Diffuser for Planted Aquarium

(1 customer review)

$44.99

Clear

Description

 

  • The Inline Co2 Atomizer achieves a super fine and high rate of Co2 diffusion
  • Total 100% dissolution in water
  • Inline design for use with canister filters
  • Simple install mounted below or directly to aquarium

The atomic inline Co2 diffuser is an easyto-use, discreet device that provides professional quality and value. It can be mounted inline with canister filters with an inner diameter of 12mm and an outer diameter of 16mm. This Co2 reactor for aquarium produces an ultra-fine mist with an average bubble size of less than 0.1mm in diameter.

When using the inline Co2 diffuser, make sure to handle with care, and avoid direct contact with the ceramic. Fill the bubble counter with water only and use only high pressure-rated, acid-resistant tubing.

A minimum of 30 PSI of pressure is required with this inline Co2 atomizer. Silicone tubing is not recommended. Clean the atomic inline Co2 for planted aquarium with a 3:1 water: bleach solution overnight every 6 months or as necessary.

Attention:  Should be used with Co2 pressure rated tubing only.  Do not use with silicone. Tubing must be acid resistant and rated for high working pressure.  Add 10ft of Co2 resistant tubing for only $10.

Additional information

Size

12/16, 16/22

1 review for Intense Atomic Inline Co2 Diffuser for Planted Aquarium

  1. backblast

    The inline atomic atomizer allows me to achieve 100% absorption rate of my carbon dioxide within my water column. I installed my atomizer inline with my Marineland Magnaflow 360 canister filter and the water entering my tank is completely mixed 100% with carbon dioxide. The micro bubbles are so small that I have to pay close attention to my outlet diffuser of my filter to see the bubbles entering the tank. The vivid and real results are seen by my plants which are growing healthy and lush due to being able to achieve the coveted 30ppm mark of co2 diffusion within the water column. I also use NilocG’s drop checker which makes it really easy to physically se when my tanks reaches the correct concentration of carbon dioxide. The atomizer is well constructed and extremely easy to install; the entire process took me no more than ten minutes. And this is due to fine running my bubble counter on my co2 regulator. However, it was really simple to have the entire system up and running in a matter of minutes. I do strongly recommend this product.

Add a review

Your email address will not be published. Required fields are marked *